Description:
In 2007, American Conveyor Corp. made a 2-level stainless steel conveyor system for my food business. It was used for 18 months, then my business was merged with another food distributor. Since then, the conveyor has been sitting in the NY storage facility, partially disassembled but otherwise in very good and operational condition.
I paid over $120,000 for this conveyor, and selling it in as-is condition for a fraction of this value.
About the conveyor: It is a 50 ft long double-layer looping system with 8 motors. The lower loop is 18" above ground, and the upper loop is 43" above ground. Loops can rotate in different directions and at different speeds, up to 43 FPM. See photos including a schematic drawing from the manufacturer. Here is what's included:
8 - Power Units (4 Double Drive/4 Single Drive)
8 - 1 ½ HP Motors
8 - Tail Sections
24 - Sprockets
189’ - Straight Fixed
6 - Double 90 Degree Curves
4 - Single 90 Degree Curves
2 - Double Partial Degree Curves
640’ - LF 882 K 10” Chain
314’ - LF 882 K 12” Chain
1 - Manual Gate
1 - Fixed Transfer (Non-Automatic Merge)
6’ - Gravity Rollers
1 - Lot of Brackets
1 - Lot of Supports
1 - Stainless Steel Electrical Control Panel for
8 Drives, On-Off Switch, E-Stop, Variable Speed, Control (4 Drives), Fixed Speed (4 Drives), Manual Motor Disconnects (8), Cable E-Stop
Original invoice and schematics available upon request.
Dimensions:
Height: 43 inches
Width: 92.5 inches
Length: 602 inches
Additional Prep Fees May Apply
