Jacketed heat transfer Screw auger conveyor, 12” x 24’ auger trough conveyor unused
Screw conveyor is jacketed, heat transfer auger conveyor, and has bolt on covers/lids: pipe size inlet and outlet 1 1/4"+- npt?, jacket approximate size area 1 inch wide/deep x 22ft long jacket wraps from front around the bottom to back side, drive shaft two pillow block bearings on drive end (Rexnord) and on tail end ( Link-Belt) auger rpm: ?, trough width 13”, flighting spacing 12”, flighting thickness1/4”, auger shaft/pipe approximate diameter 2 ¾” +-, bottom discharge 12” x 13”, overall outside length of conveyor 27 ½ ft, Toshiba 2HP, 1750 rpm, 230/460 volts, Dodge speed reducer ratio 25.06, stored inside, can provide demonstration video of conveyor running, contact us for a freight rate.
Additional Prep Fees May Apply
