Browse our other Chillers
Refrigerant CircuitAir-cooled condenser with finned tubesPropeller fan(s) induced air flowRefrigerant sight glass with moisture indicatorFilter-drierThermostatic expansion valveR410A refrigerant– Non-Ozone depleting– Low global warming impactBrazed plate evaporator– Stainless steel plates– Copper brazing materialLiquid line solenoid valveDigital Scroll compressorEnergy efficient capacity control from 20% – 100%Coolant CircuitInsulated non-ferrous reservoir(tank lid is standard on this model)Reservoir level sight glassStandard NPT process fittingsHigh flow centrifugal pumpFull Load Amperage230/3/60: 56460/3/60: 28575/3/60: 23Reservoir CapacityHolding: 25 galLid: StandardAuto Make-Up: OptionalProcess ConnectionsTo Process: 1-1/4″From Process: 1-1/4″Make-Up: 1/2″DimensionsHeight: 60″Width: 34″Depth: 56″Weight Shipping: 1,100 lbsCGD Series ControlGraphic LCD Display with Intuitive NavigationDigital Refrigerant Pressure DisplayDigital Water Pressure DisplayPlain Language Error Message ReportingControls Hot Gas Bypass for Capacity ControlAlarm Output with Audible SignalIndustry 4.0 Ready Modbus RTU included – TCP optionalHigh Water Temperature Shut Down*1. Since product innovation and improvement is our constant goal, all features and specifications are subject to change without notice or liability. Selection of certain optional features may change listed specifications.2. Tons capacity at 12,000 BTU/ton per hour @ 50°F LWT @ ” 115°F condensing temperature. Capacities may be +/- 5% as reserved by the compressor manufacturer. Operating at temperatures below 50° will reduce chiller capacity. The minimum recommended operating temperature when no glycol is used is 48°F.3. Design ambient conditions. Loss of capacity and/or difficulty operating will occur at higher ambients. Minimum recommended ambient is 60°F.4. Full load amps are higher than run load amps and must be used for sizing disconnects and supply wiring.Additional Prep Fees May Apply